Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
this was a very long time I have not come to this forum and i have one question.
Generaly, i use Ansoft designer to make my RFID antenna, so i would like to try CST Microwave by exporting a dxf design.
I have a little big problem: i don't know how can i place my RF port (My chip impedance is: A jB).
I try to make that:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.