Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

RF switch device width

Status
Not open for further replies.

jcpu

Full Member level 4
Joined
Dec 17, 2005
Messages
215
Helped
18
Reputation
36
Reaction score
6
Trophy points
1,298
Activity points
2,968
I am designing RF switch.
And need advice about how switch device width is decided.
Thanks in advance.
 

eagle5

Member level 3
Joined
May 24, 2011
Messages
55
Helped
29
Reputation
58
Reaction score
28
Trophy points
1,298
Location
Mediterranean
Activity points
1,547
I think that the switch width is going to depend on the power handling required and isolation level. The wider the switch is, higher the power handling but lower the isolation in OFF-state.
 
  • Like
Reactions: jcpu

    jcpu

    points: 2
    Helpful Answer Positive Rating

jcpu

Full Member level 4
Joined
Dec 17, 2005
Messages
215
Helped
18
Reputation
36
Reaction score
6
Trophy points
1,298
Activity points
2,968
Then please advise the device width you are using and how much power it's handling?
Thanks,
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top