Pardon me, I meant to say buffer and not isolate.Hi,
I don´t understand. Neither a BJT nor a FET provides isolation.
What´s your idea.
Maybe a sketch could help.
Klaus
I don´t understand. Neither a BJT nor a FET provides isolation.
Yes and No..Thanks for the responses.
My only experience of RF amplifiers before this is some power amplifier design. For the circuit configurations mentioned, assuming 50 ohm source and load, would they require matching networks like a power amplifier does?
Cheers.
By "splitting" the signal, you mean with a power splitter circuit (wilkinson splitter, etc)? Or do you need buffers for each load? How much isolation do you need from one load to another? Are the loads connected by PCB traces, or cables?The load is reasonably 50 ohm but there could be some slight variation and I'm going to be splitting the signal a number of times so want to isolate the osc output from this.
Cheers.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?