Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
if you disable the reset pin and use it as an I/O then you can no longer use ISP, you can only use a parallel programmer,
In fact I'm not sure if you can change the reset fuse while connected with a serial programmer, I think you need a parallel one to change it.