Mithun_K_Das
Advanced Member level 3
- Joined
- Apr 24, 2010
- Messages
- 899
- Helped
- 24
- Reputation
- 48
- Reaction score
- 26
- Trophy points
- 1,318
- Location
- Dhaka, Bangladesh, Bangladesh
- Activity points
- 8,252
Do you have any experience with new version of GLCD v2.0? I had a design working few years ago. Recently I bough this
new GLCD for that design. But When I connected it, it work improperly. Almost no output and noise in the Display. Here you can see that this new version has PSB and NC (No connection May be) pins rather than CS1 and CS2 of old version. I searched over internet, and found some articles about this new version. But not that much clear. Somebody says PSB is to select serial or parallel operation. Also there is a JP2 point for that serial/parallel operation. but there is no effect I found rather than consuming extra current(normally the whole circuit consumes only 40mA, but with serial input selection it consumes 160mA !!!).
Now my question is, what is the difference between this new version of GLCD and old version? And how can I replace that old one by this new one? I'm working with MikroC pro for PIC.
Now my question is, what is the difference between this new version of GLCD and old version? And how can I replace that old one by this new one? I'm working with MikroC pro for PIC.