Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Removing error popup in LTspice

Status
Not open for further replies.

patan.gova

Full Member level 3
Full Member level 3
Joined
Dec 19, 2011
Messages
172
Helped
4
Reputation
8
Reaction score
0
Trophy points
1,296
Visit site
Activity points
2,776
Hello,
I am gettiing some error popup in LTspice as shown in the attached image when I tried to simulate the sallenkey bandpass filter combined with:

a) sallenkey HP filter with fc=0.4Hz **broken link removed**

b) sallenkey LP filter from here with fc=2.4Hz **broken link removed**

Can someone suggest me how to get the response of the filter and how to make the current one with butterworth response.
thanks.

**broken link removed**
 
Last edited by a moderator:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top