zeebri
Newbie level 4
RapidIO & SAE AS6802-TTEthernet using Dynamic Timing & Power Simulation(Webinar)
RapidIO and Time-Triggered Ethernet are used in many overlapping applications including Avionics. While TTEthernet has deterministic transfer delays, RapidiO provides extremely high data rates. Both standards provide significant flow control, priority based transfer, and virtual link mechanism. To select the right standard for the target application, you can review the 1000 page standard or set up different physical hardware configurations. Both are time-consuming, expensive and pertain to the test system alone.
In this Webinar, we run simulations of multiple target applications, workloads and network configurations for both standards. From these simulations, we review the results and discuss the relative merits. We used the RapidIO 3.1 standard and SAE AS 6802 specification respectively. During this webinar we will show the simulation setup, outputting results and interpreting them. We will use the fully validated VisualSim RapidIO and VisualSim TTEthernet modeling libraries for the modeling and simulation effort.
Takeways:
Learn the nuances of both standards
Learn a simulation-based methodology to compare different protocols
Interpret the latency, throughput and power consumption reports for multiple concurrent applications
Europe/India/China USA/Canada/Brazil
Wed, June 22nd, 2016 Thurs, June 23rd, 2016
11 AM CET/3:30 PM IST/6 PM CST 11 AM PST/2 PM EST/3 PM BRT
Duration : 45 Mins
Speaker : Deepak Shankar, CEO, Mirabilis Design Inc
To Register for our webinar, Click here
RapidIO and Time-Triggered Ethernet are used in many overlapping applications including Avionics. While TTEthernet has deterministic transfer delays, RapidiO provides extremely high data rates. Both standards provide significant flow control, priority based transfer, and virtual link mechanism. To select the right standard for the target application, you can review the 1000 page standard or set up different physical hardware configurations. Both are time-consuming, expensive and pertain to the test system alone.
In this Webinar, we run simulations of multiple target applications, workloads and network configurations for both standards. From these simulations, we review the results and discuss the relative merits. We used the RapidIO 3.1 standard and SAE AS 6802 specification respectively. During this webinar we will show the simulation setup, outputting results and interpreting them. We will use the fully validated VisualSim RapidIO and VisualSim TTEthernet modeling libraries for the modeling and simulation effort.
Takeways:
Learn the nuances of both standards
Learn a simulation-based methodology to compare different protocols
Interpret the latency, throughput and power consumption reports for multiple concurrent applications
Europe/India/China USA/Canada/Brazil
Wed, June 22nd, 2016 Thurs, June 23rd, 2016
11 AM CET/3:30 PM IST/6 PM CST 11 AM PST/2 PM EST/3 PM BRT
Duration : 45 Mins
Speaker : Deepak Shankar, CEO, Mirabilis Design Inc
To Register for our webinar, Click here
