inferno_nsit
Newbie level 5
Hi,
I am implementing a mmc card reader using atmega 32.I am using the FATFS LIBRARY from
**broken link removed**
after reading the code i had some doubts
1.what does the xatoi() and xitoa() funtion do and what is meant by them connected with the UART module.
here is a sample run of the code
http://elm-chan.org/docs/mmc/sd128.txt
2.what do the 5 columns display in using the fw command.?
3.Where are we writin the commands ...is it on the hyperterrminal or any other interface?
Hope someone replies
I am implementing a mmc card reader using atmega 32.I am using the FATFS LIBRARY from
**broken link removed**
after reading the code i had some doubts
1.what does the xatoi() and xitoa() funtion do and what is meant by them connected with the UART module.
here is a sample run of the code
http://elm-chan.org/docs/mmc/sd128.txt
2.what do the 5 columns display in using the fw command.?
3.Where are we writin the commands ...is it on the hyperterrminal or any other interface?
Hope someone replies