Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

question about how to change LTspice default path

Status
Not open for further replies.
W

winglj

Full Member level 4
Joined
Feb 21, 2005
Messages
195
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,063
Hi, everyone. I have a question about how to change the LTspice default path.

I found that this software only allow the user choose the component symbols from the current path or the software default path. Actually even I add a sub-folder in its default path, it didn't show up in the software for selection. I am wondering are there any ways to change its default path somewhere else in the computer?

Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top