[SOLVED] Pwm out put through rc0 & rc1

[m.naveed]

I'm confused after seeing a circuit with pwm signal for a 50Hz inverter which used RC0 & RC1 of P16F887.
RC1 is CCP2 out put its ok but how RC0 works same as RC1?

 

[amayilsamy]

Post your schematic with code....

 

[m.naveed]

actualy Ii'm trying to work with ccp module of 16F887 and not well aware of it I seen a ups control card havin g the same MCu but it confused me as only one ccp module pin is used.
there are 2 same similar portions of circuit as shown in fig both drive a module conected to a center taped transformer to give ac out put.
I don,t hav e code but I knew its output i.e. 50Hz square wave with a 180 phase difrence as it is for a single phase Ac invert