Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PWM i.cs in proteus

Status
Not open for further replies.

Mehboob Aam

Newbie level 4
Joined
Mar 24, 2015
Messages
7
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
54
I was trying to make a push pull inverter using SG2524/SG3524/4047, but I can not find any PWM i.c in proteus, except some of expensive and high wattage modules. is there any i.c available in proteus library for PWM simulation, or is it possible to download above mentioned i.cs into the proteus library ?

shall be thankful for your kind and worth helpful response.
 

Mehboob Aam

Newbie level 4
Joined
Mar 24, 2015
Messages
7
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
54
thanks a lot kabeer02, i downloaded the .rar folder and have extracted it. but how to use these files, as it has different file formats for each model, which format should be placed in which folder of proteus installation directory. i tried by copying all files for each model in to directories , MODELS, and LIBRARY. but when i opened the proteus software and search for 494/UC2524 etc i could not found any in add-part-from-library section of proteus.
 

kabeer02

Full Member level 5
Joined
Nov 23, 2012
Messages
301
Helped
57
Reputation
114
Reaction score
54
Trophy points
1,308
Location
yamasukro
Activity points
2,475
well i have both on my system but i only use it on 7.10 version i didnt try it on ver 8.0
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top