Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Pushpull transformer leakage inductance?

Status
Not open for further replies.

cupoftea

Advanced Member level 5
Joined
Jun 13, 2021
Messages
2,523
Helped
54
Reputation
108
Reaction score
110
Trophy points
63
Activity points
13,202
Hi,
We have a pushpull transformer, NP/NS = 4/8
ie pri is 2 coils each of 2 turns
sec is 2 coils each of 4 turns.

Leakage inductance measured at one primary "half" was 100nH....this was with all three secondary wires shorted together.

As such, do you agree, the leakage is 50nH in primary "half" 1; 50nH in primary "half" 2; 200nH in secondary "half" 1; 200nH in secondary "half" 2.
 

There was only one leakage inductance figure taken......that 100nH...no other measuremet was taken...so i guess i dont know.
You mean short one pri half and measure the inductance of the other?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top