hello
I would want ot know if it is possible to have a generic DAC (and ADC) in pspice (I use Orcad suite for simulation) ? I know that Simetrix permit to setup custom model, does pspice could do it too ?
I cannot check at the moment, but if you have SIMetrix, generate an ADC and look at the netlist. If it looks like a Spice subcircuit you could cut & paste it into Pspice.
A DAC wouldn't be too tricky - an R2R ladder and perfect buffer.
If you run a simulation with the DAC or ADC in SIMetrix and then look at either the 'design.net' file or the list/output file you should be able to see what has been used in the simulation. It may be a macro using SIMetrix syntax, or it may be a Spice subcircuit - I am not sure.
Keith
Added after 30 minutes:
I have managed to do a quick check and it calls up models in the bridges.lb library, but I am not sure it helps much.
Does Pspice support Xspice digital models? bridges.lb is the link between Xspice and Spice. If Pspice supports Xspice then the model in bridges.lb may also work.