Make the circuit - cir.1.
Change the value of resistor - cir.2.
Call PARAM, open Properties, make a new column, name it "f" and give it a value (1kHz in the case) - cir.3. Dont forget to display the value (at least).
Put a voltage marker to watch the output - cir.4.
Make a new simulation profile and fill in: Time domain (transient), Run to time (5ms in case) and Maximum step size (50u in case) - cir.5.
Mark the option: Parametric Sweep, check as sweep variable "Global parameter", give the appropriate sweep type (Linear in the case) and define the name, start and end value, as well as increment (f, from 10Hz, to 10k, with step of 1kHz in this case) - cir.6.
Start simulation and watch the result - cir.7.