No, hehe, i am not talking about anything sophisticated, just navigating inside a schematic.
I already configured several Keyboard Mappings, but i am asking if the panning through the middle button works that way, or is just my case for some weird reason. I could remember this behavior is also in previous versions of Proteus, but not fully sure.
By changing the priority setting of the Windows Process in the Task Manager put into High instead of Normal didn't have any effect.
Proteus:
- Click and release middle button, for enter panning mode,
- Do panning through the sheet, on the viewable screen,
- Click and release again, for exit panning mode.
Other software:
- Click and hold for enter panning mode,
- Do panning,
- Release for exit panning mode.