Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PROTEUS LITE AND 16F84

Status
Not open for further replies.

ccronin4

Newbie level 6
Joined
Jan 7, 2002
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
australia
Activity points
14
proteus 16f84

i WORKING THROUGH A project that is using a 16F84 chip in proteus lite the library does not seem to have a 16F84 but a !6F84A i statred to use this but when I went to connect pin 5 VSS and pin 14 VDD they were missing from diagram . I need direction
chris
 

S

sick_man

Guest
proteus lite

dont worry about these pins being missing


when it comes to simulation it add these pins
they are there but hidden

then you need only VCC or VDD andGND terminal in your design

when you come to route in pcb it will add the vcc etc to the correct rail

determined by where you place the power label {little arrow for power }
after clicking gadget mode tool
and i/o and add gnd and power rails you need

the chip will then auto wire to the correct directive label rail


x000
0000
0x00
0000
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top