Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

protel to dxdesigner schematic translation

Status
Not open for further replies.
M

mannou

Newbie level 3
Joined
Aug 15, 2008
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
Hi all,

I'm a new PADS user, when I convert the schematics in Protel to DxDESIGNER, and I run a design rule check it generates lots of errors for example the translation duplicates the two ampliop and generates an error of duplicates pin and undriven net. I can’t manage all this errors and I can’t simulate the circuit with DxDesigner!
Did the translation import the parameters of different parts and their spice model ?
Can anybody help in this ?

Thanks in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top