programmer for atmega32?

[monil]

atmega32 programmer

i want a programmer and programming software to burn hex file in atmega32. i am using vistax64 OS. I dont have parallel port but i have usb to serial converter.
please help me......[/b]

 

[Eugen_E]

serial programmer for atmega32

The USB to serial converter can be used with Ponyprog: ... but i heard from many people that using a converter the chip programming is very slow compared to a serial port, depends also on the converter chip.

Better use these programmers + AVRDUDE + GUI:

https://www.fischl.de/usbasp/
https://www.ladyada.net/make/usbtinyisp/

The problem is you first need to program once the uC in the programmer, but I think you can find an old PC with serial port for this.

 

[pranam77]

programer+atmega32

"Keeprog" an USB programmer for AVR devices from United7 technologies is available for just 500 Rupees. Have more details from this link below. Good luck
www.united77.com/keeprog.htm

 

[shouvikroy]

The serial programmer from www.lancos.com which can be used with Ponyprog will not run by a usb-serial converter as these programmers do not use the standard RS232 protocol. To program a AVR its better to go for a usb programmer. The cheapest and most reliable solution. You can find one from shop.extremeelectronics.co.in for about rs 350/- note: Be sure to check compatibility with vista 64 bit..cheerz

 

[Tahmid]

Hi,
I use the TOP2005 programmer which uses the USB port directly and can program almost all the AVRs, plus many other chips, like the PIC microcontrollers and others.
Hope this helped.
Tahmid.

 

[Capelu]

A simple and working programmer for Atmega32 ,builded and tested yesterday from me.

Personal i used BC547 instead of BC846.

This is ISp programmer ,what mean you have need tu use power from Your Board.

I hope this will help.
Software for use with this programmer is Ponyprog.

I`m not sure if work with usb to serial converter but is very simple and easy to try.

 

[nandhu015]

I`m not sure if work with usb to serial converter but is very simple and easy to try.

I had tried 3 type of usb to serial converters and found not working.

Nandhu

 

[anandpv2009]

Ya...
Serial to USB cable won't work....

Hi,
I use the TOP2005 programmer which uses the USB port directly and can program almost all the AVRs, plus many other chips, like the PIC microcontrollers and others.
Hope this helped.
Tahmid.

I don't like TOP2005 because it does't support 16bit,32bit,18F series PIC controllers.

 

[Capelu]

I`m not sure if work with usb to serial converter but is very simple and easy to try.

I had tried 3 type of usb to serial converters and found not working.

Nandhu

To bad!
It good to know. I was thinking to buy my self a usb to serial converter for programmers.
Thanks for saving my money.