Problem with simulating surface currents in CST

Status
Not open for further replies.

pepillo

Advanced Member level 4
Joined
Jan 23, 2006
Messages
114
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,296
Location
Spain
Activity points
2,382
Surface currents in CST

When I try to simulate surface currents in CST it says that "current monitor only considers electric conductivity and will be ignored for dispersive material behaviour". How can I fix this? I am using PEC for the SMA connector and Copper for the microstrip line and ground plane. What's wrong????
 

Surface currents in CST

may be it means that copper is a metal and thus dispersive ?

try to make all the materials PEC and see what will happen.

However, I think the problem is somewhere else. I do not believe that CST Microwave Studio cannot simulate the surface current on the a microstrip antenna feed
 

    pepillo

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…