Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with simulating surface currents in CST

Status
Not open for further replies.
pepillo

pepillo

Advanced Member level 4
Joined
Jan 23, 2006
Messages
114
Helped
3
Reputation
6
Reaction score
0
Trophy points
1,296
Location
Spain
Activity points
2,382
Surface currents in CST

When I try to simulate surface currents in CST it says that "current monitor only considers electric conductivity and will be ignored for dispersive material behaviour". How can I fix this? I am using PEC for the SMA connector and Copper for the microstrip line and ground plane. What's wrong????
 

Surface currents in CST

may be it means that copper is a metal and thus dispersive ?

try to make all the materials PEC and see what will happen.

However, I think the problem is somewhere else. I do not believe that CST Microwave Studio cannot simulate the surface current on the a microstrip antenna feed
 

    pepillo

    pepillo

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top