Problem with receiving data on MCP2200

Status
Not open for further replies.
K

kanch

Newbie level 1
Joined
Nov 25, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,289
hello everyone,

i am new user to this forum.i have some problem while working with mcp2200.please help me...

i am using mcp2200 which is usb to serial convertor .i got it configured successfully from pc but when i send data serially to usb connector part of mcp2200(D+ and D- pins),i didnot got it on TX pin of MCP2200.For the configuration from pc i used the configuration utility provided by microchip and setting done is as follows


and the hardware is as follows


so if anyone had worked or know how to solve the problem then ,please reply to this thread..
 

Re: problem with mcp2200

dear kanch...

Please confirm the following

1. what is the baud rate configured on mcp2200 and your serial window (like hyperterminal or target board)
2. Why CTS/RTS from mcp is connected with max3232 tx and rx pins? Did you referred this circuit somewhere?

Thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…