Problem with programming AVR chips using ponyprog serial and parallel dampers

Status
Not open for further replies.
S

syeda amna

Full Member level 4
Joined
Jun 1, 2010
Messages
222
Helped
24
Reputation
48
Reaction score
22
Trophy points
1,308
Location
Pakistan
Activity points
2,551
hi
i m facing difficulty in programming AVR chips. i use ponyprog serial and parallel dampers but fails to program my chip.
how can i do this? suggest me please.
 

Re: AVR programmer

where is you problem, hardware/software ?
common stuff I used to face
what programmer are you using?
Is your avr ok? (didnt you disable reset/spi programing accidentally/ set clock external clock)
what port are you using? is it ok? is it capable of programing with speed(setted delay to maximum?)
are you powering externally your chip? are your cables long? ....
have you checked ponyprog FAQ's ?
 

    S

    syeda amna

    Points: 2
    Helpful Answer Positive Rating
Re: AVR programmer

thanks for your reply
my chip, my software are correct
i try both serial and parallel cable
i dont know about the other possibilities that u have written. i will check them. please guide me.
 

Re: AVR programmer

hi
i still have some problem.
i m using the most simple avr parallel progrmmer.

can u send me the schematic of your pogrammer
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…