Re: integrator
i am using voltage controlled voltage source to model the op-amp. so i consider the op-amp as an ideal op-amp. what i did was that i connect the negative output of the voltage controlled voltage source to groud. positive input, negative input, and positive output of the voltage controlled voltage source are connected just like what you would connect to an op-amp.
i also change the inital condiction of each node voltage to 0V. that was how i got the voltage down to around 600 volts. under simluator -> convergence aids -> initial condition, you can change the inital voltage of each node. if the initial conditions are not set, dc steady state values are used instead when finding the transiet reponse.
so yea...i still dont understand why the integrator is not working as it should.
the input is fine...but the output....sigh
any suggestion? thanks in advance.