Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with numbering of the Euro Connector pins

Status
Not open for further replies.

Anonymous_Ricky

Advanced Member level 2
Joined
Dec 26, 2006
Messages
517
Helped
88
Reputation
178
Reaction score
58
Trophy points
1,308
Location
India
Activity points
3,974
Hi all,

i am having problem in numbering the pins of Euro Connector(to be used in daughter Card) from datasheets it is not clear.
kindly help me out
.
Attached is the connector footprint made with pin numbering
regards,
Ricky
 

Rame

Full Member level 6
Joined
Dec 23, 2005
Messages
373
Helped
47
Reputation
94
Reaction score
7
Trophy points
1,298
Location
BANGALORE
Activity points
3,813
Re: Euro Connector

Hi,

It starts from left as 1 and ends with 32,then again it starts from the left as 33 and and ends right as 64,in same fashion it again starts as 65 from left and ends as 96 to the right.

It is like starts from left and ends at right,like mirrored Z,Zig zag,like the one below,don't forget to add the mounting holes,its very important.


You can always ask for the datasheet from where you are procuring the components...


65 oooooooooooooooooooooooooooooooo 96
33 oooooooooooooooooooooooooooooooo 64
1 oooooooooooooooooooooooooooooooo 32





Regards

Ramesh
 

Anonymous_Ricky

Advanced Member level 2
Joined
Dec 26, 2006
Messages
517
Helped
88
Reputation
178
Reaction score
58
Trophy points
1,308
Location
India
Activity points
3,974
Euro Connector

Thanks Ramesh ,
I have made my footprint in the same order.
thanks once again.

Ricky
 

sigint

Full Member level 6
Joined
Dec 31, 1999
Messages
360
Helped
22
Reputation
44
Reaction score
7
Trophy points
1,298
Location
State of total unemployment
Activity points
1,667
Re: Euro Connector

Not correct - bottom left is A1 thru bot right A32, middle row is the same only "B1 thru B32" top is "C1 thru C32"

SiGiNT
 

Anonymous_Ricky

Advanced Member level 2
Joined
Dec 26, 2006
Messages
517
Helped
88
Reputation
178
Reaction score
58
Trophy points
1,308
Location
India
Activity points
3,974
Euro Connector

hi sigint,
Actuaaly I am using Zuken which donoty support the pin numbering as A1 A2 .....
In Zuken we give the numbering as told by Ramesh.
Thanks anyway.

Regards,
Ricky
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top