Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with Nokia 3230 switching off

Status
Not open for further replies.

gravi

Full Member level 2
Joined
May 30, 2006
Messages
128
Helped
10
Reputation
20
Reaction score
10
Trophy points
1,298
Location
Hyderabad, India
Activity points
2,452
Hi
I have cleaned cell mother board with Isopropellent(dipped into IPA and cleaned with brush) after drying I have assembled and switched onn but it's getting switched off after some time. can anybody help me

Ravi
 

Re: Nokia 3230

Hi,
This is Ravi, I have got Nokia 3230, which fell into water long back and began to work after a couple of day's that's fine but recently some key's on keypad failed to work so dismandled I changed the inner keypad. when I was changing I found some grease material and rust here and there on the circuit board so I cleaned entire circuit board with Isopropellent and assembled it after drying.

Now when I switch ON Blank screen(failed to boot) is displayed and switch's OFF automatically after some seconds. can anyone give me any suggestion to repair my mobile.

Thankingyou,
Ravi
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top