Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with mobile sensitivity inside a house

Status
Not open for further replies.
X

xinxin

Full Member level 3
Joined
Oct 8, 2003
Messages
184
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
1,238
mobile sensitivity

When test a PCBA through the test port near the anetena port about its sensitivity , it's good , but when put it into the house , and test its sensitivity through the anetena , it results in bad sensitivity . My phone is GSM and DCS1800 and PCS1900 with dual displays. i already judge that its LCD display (sub-board) results its bad sensitivity ,but don/t know how to debug and improve it, could u help me?
 

mobile sensitivity

One possibility is the digital part is radiating into the antenna. Is this a new design or one sample of a commercial unit?

Can you temporarily turn off the display by cutting the trace from the logic clock and removing any timing capacitors of RC oscillators?
 

Yes , it's a new design , why remove any timeing capacitors of RC oscillators?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top