Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with heaterblock simulation

Status
Not open for further replies.

davorin

Advanced Member level 3
Advanced Member level 3
Joined
Jun 7, 2003
Messages
901
Helped
11
Reputation
22
Reaction score
4
Trophy points
1,298
Location
Switzerland
Activity points
7,349
Heater simulation

Difficult to choose right forum here...but it has more to do with math and simulation than everything else..


I have a heaterblock and a K-type thermocouple sensor and want to acquire the step-response of the system when turned on 100% cycle...


1. Is this step-response enough for calculating the right parameters for controlling the temperature then?

2. Is there anything in Matlab I can use for this?

3. Never done anything like that before (o;
 

Re: Heater simulation

Making feedback systems for this use is very difficult. There are several poles in the system. this is why house heating systems are "crash-bang" with full on and off at temperature limits.

I would suspect that you would have to do an experiment where you record the thermocouple output over time from a cold start and full heating power. From this graph you can do a curve fit and get a polynomial for the poles and zeros.
 

Heater simulation

Another option is to use Fuzzy Logic technology. I notice that most of the heater (for bathroom) are built around Fuzzy Logic technology.
 

Re: Heater simulation

Well..the application is more delecate than that (o;

Generating a temperature profile for BGA soldering (o;


Or is there a way to extract the neccessary duty cycle for a specific temperature?
 

Heater simulation

Davorin, you can simulate transient response by using CosmosWorks, for example, or other FEM soft such as FEMLAB.
Then you may find transport delay (td) and get polynominal as flatulent writes. The transport delay is time from beginning of heating till beginning of temperature changing at the point where temperature sensor is installed. After this procedure you can use simulink to simulate your temperature stabilization system. A propos, FEMLAB may be used with simulink seamless.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top