Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with drill files on Allegro PCB editor

Status
Not open for further replies.

cocopa

Junior Member level 2
Junior Member level 2
Joined
Feb 13, 2012
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,508
Hi! I'm using Allegro 16 and I'm having some problems with the drill files. I sent the files to the manufacturer and they said that the holes weren't alligned.. What procedure do i follow to generate the drill files when i'm using blind vias?
Thank you.
 

Did you had your Artwork and NC drill parameters same if they are different then misalignment happens in data also check for scaling
 

The only difference is that while creating artwork i had checked the "supress leading zeros option" and at nc drill parameters i had checked the " supress trailing zeros" option.
Could it be causing the problem?
 

It could be, try regenerating gerber files checking either of two.
 
  • Like
Reactions: cocopa

    cocopa

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top