Problem with codes for SHT11 with Bascom 8051

[Trishool]

Hi ,

Anyone tried writing codes for SHT11 with bascom 8051 , I am doing but there are some errors ,
all the time the Humidity and temperature O/P is:

Humidity = 5
Temperature = -10

I dont know why this , is the sensor faulty , or there is some probs with the coding . Anyone has done this before using bascom8051 compiler .


Regards
Ts

 

[laktronics]

sht11 bascom

Hi,
Since BASCOM allows assembly routines, may be you can write routines in Assembly for basic measurement, have a look at the post for some ideas for assembly routines, if it helps you.
Regards,
Laktronics

 

[chethankp]

Re: SHT11 B@scom-8051

Hi,
I'm using a 8051 based SOC(CC2430 from TI) and it a 32MHz
I went through the sample codes given in the SHT11 data sheet . But they didnt tell about how to get an 1MHz clock cycle..
and also they are using a bi directional pin to put the data OUT and IN..
But My device wont support that bidirectional pin.. How to do that..

Pls help me.. I'm struggling for this...


regards
chethan