Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The most likely reason is something on your board is loading down the signals from the Pickit 2. It probably can't reach the required voltage levels or timing because other components are preventng them being reached.
Please keep the wires from the Pickit as short as possible and tell us how you have it connected to the PIC you are programming.
This is how I connected PIC to PICkit 2 Programer.
For your info, the first PIC is new too,just get from the shop. :sad:
I try it over and over again.
Lastly, I bought new PIC and replace it.
Thanks all. Problem solved.
Before Programming Try to check Supply, ground & other connection if u fresh start because due to this IC may get damage. Avoid reverse insertion of IC
Seems the problem is solved but beware of 'clones' of Pickit2, that isn't a real one and many copies are not fitted with all the electronics of a genuine one.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
This is how I connected PIC to PICkit 2 Programer. 
