[SOLVED] Problem to load HEX file to PICkit 2 Programer

[Ishah]

Hi All,

Need your solution for this problems.

Thanks.

 

[betwixt]

The most likely reason is something on your board is loading down the signals from the Pickit 2. It probably can't reach the required voltage levels or timing because other components are preventng them being reached.

Please keep the wires from the Pickit as short as possible and tell us how you have it connected to the PIC you are programming.

Brian.

 

[Golden Electronics]

May be ur IC damage try for new IC if it work then PICkit2 ok but IC damage.

 

[Ishah]

This is how I connected PIC to PICkit 2 Programer.

For your info, the first PIC is new too,just get from the shop. :sad:
I try it over and over again.
Lastly, I bought new PIC and replace it.
Thanks all. Problem solved.

 

[Golden Electronics]

Before Programming Try to check Supply, ground & other connection if u fresh start because due to this IC may get damage. Avoid reverse insertion of IC

 

[aameer]

Change your micro controller...

 

[betwixt]

Seems the problem is solved but beware of 'clones' of Pickit2, that isn't a real one and many copies are not fitted with all the electronics of a genuine one.

Brian.