problem in metamaterial simulation

Status
Not open for further replies.
S

sachin kalraiya

Newbie level 2
Joined
Aug 24, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
0
i simulate a SRR unit cell in HFSS but when I change the height of the radiation box ,result have change so what should be the height of the box .Please help me ,it is very urgent.
 

when I change the height of the radiation box ,result have change
Click to expand...
I guess, you made a mistake in Setting up the boundary conditions.
what should be the height of the box
Click to expand...
I used half a wavelength above and below the SRR/Substrate.
it is very urgent
Click to expand...
How can that be urgent, it has been published extensively in the past 6-8 years.
Search the edaboard for fss and check the entries 2005 to 2007. I'm pretty sure, we discussed this topic by that time.
 

There are numerous *spurious* modes which exist on the fast-wave side of the light-line, whose frequencies scale with the height of the box/boundaries.

If you are sure you have the correct mode, then cd79 is correct that you've most likely made a setup error.
 

In addition to everything that's been mentioned, you should be using Floquet ports to excite the unit cell. After that, it's simply a matter of solving for the appropriate number of modes. This will be displayed in the modes calculator, and will vary based upon frequency, unit cell size, and scan angle.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…