Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem in Interfacing controller(MC1322x ) and GSM Module(GL865)

Status
Not open for further replies.
N

nlsatish26

Newbie level 1
Joined
Dec 21, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
Hi,
I am interfacing controller(MC1322x) with GPRS modem(GL-865).

I did the following-
1. Program MCU to send AT command using UART (printf) and receive the response using scanf function.
2. Connect the serial cable from MCU to (Max 232)gprs modem serial port.
3. reset the MCu to send the AT command to GPRS module.

But I got no response from the GPRS module. Did I miss anything? Do I need extra initialisation? Or anything else?
TTL logic of controller board(Rx and Tx is 2.8V logic) which is ideal to communicate with the GSM Modem but I'm not getting any response from the modem

My simple code to send AT command is (IAR)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top