Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards

Status
Not open for further replies.
H

Haris007

Newbie level 2
Newbie level 2
Joined
May 3, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,296
In IEEE document, Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards, I have the problem to made another side which is right side of spline whereas Left hand side is made correctly in HFSS. How to make it?

Secondly how to made two bottom rectangles which is back side.

Thirdly, one large rectangle has to be made but I have doubt that either I will draw box or rectangle but hfss shows that rectangle with equal side is not possible.

PDF file is also attached.

Please help me for three problem that i have discussed above.
 

Attachments

  • 06104348.pdf
    741.7 KB · Views: 124

How far exactly have you progressed in your hfss design ? The previous post is not very clear. If you upload your hfss file, I can take a look at it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top