gepinita
Junior Member level 1
I am setting the voltage of each cell in the design by using the following command :
set_voltage 0.9884 -cell instancename -pg_pin_name VDD
I am performing timing analysis but i get the same results with the nominal voltage timing analysis.
I want to perform a power driven timing analysis based on the new values that i have set and not on the nominal voltage of the design library i use.
Does anyone know how can i do this?
Thank you in advance.
set_voltage 0.9884 -cell instancename -pg_pin_name VDD
I am performing timing analysis but i get the same results with the nominal voltage timing analysis.
I want to perform a power driven timing analysis based on the new values that i have set and not on the nominal voltage of the design library i use.
Does anyone know how can i do this?
Thank you in advance.