Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
To eradicate such an issues isolation blocks are used after output of ON_OFF blocks(power off modules) .
which it wont give a floated values to the inputs of the other blocks or dependent blocks
this is done in two sections @ rtl level power intent verification (new concept)
2ndly@after synthsis :they place isolation blocks b/w modules.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
