Power reported in Magma is too high

Status
Not open for further replies.
C

chetanbs

Member level 2
Joined
Aug 9, 2006
Messages
47
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,288
Activity points
1,581
Hello,

The core power reported by magma for a design is around 1.1W. Is there any way where I can change the power value to say around 0.6W? I have read somewhere that this is possible. Please let me know....

Thanks in advance,
Chetan
 

i have joined edaboard.com recently,

you can you the following command to mentioned hard coded power value.

force cell power <design_name> <power_val_in_watts> -type core_cells -scale

and for a macro you can you the following command

force cell power <design_name> <power_val_in_watts> -down_model <lib_model>


Regards,
vikram
 

welcome to edaboard!!

thanks a lot for the reply!

after a bit of thinking, got that these commands do only analysis and then scale down the power if required. something like a "what-if" kind of analysis!!

would not the switching activity defined on data and clocks be too pessimistic in this case, since in real scenario, all the data nets and clock nets would not be switching at the max speed at all the instances.... can anyone throw some more light on this
 

Be careful to just change the power value. How do you know it is not real? I'm sure Magma is calculating the power from the models...are the models characterized properly?
 

Dear dudes,

In Magma,While Doing Voltage Drop analysis,Wat is use of “config cell voltage On” Command. Wat wil be the change in IR Report as wel as Timing Report By Enables this cmd???

Regards...
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…