power estimation & power table (when used in DC & PTPX)

Status
Not open for further replies.

childs72

Member level 1
Joined
Apr 8, 2006
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,542
Hi,

I had ran power estimation on DC & on PTPX (with .vcd file). I used same libraries for both tools. DC is able to report power without warning/error. However, PTPX complaint one of my IP does not have valid internal power table in its library...
1. After opened the .lib of the IP, I found that there is only 1x2 power table (while my other libraries generally have bigger power table). Is this the reason PTPX consider this is not valid table?
2. Why DC does not complaint about invalid power table?

Thanks.
 

DC doesn't do a great job at estimating the power numbers. It is not designed to do this. PTPX is the right tool.
The flow
DC gets the netlist --> P&R--> Prime_time ( so that the timing is fixed with the correct slews and loads)....
and then PTPX which can read in the constraints along with the post_layout parasitics+timing info for calculation of the dynamic power.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…