Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Post Layout Simulation of design after SPR in Tanner

Status
Not open for further replies.
U

uandme

Newbie level 1
Newbie level 1
Joined
Jan 3, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
7
Hi Everyone,

I am designing an NCO using Tanner EDA. After simulating & verifying the design in S-Edit, i have generated the TPR file and completed the SPR also. is it possible to do post layout simulation after SPR. if so, kindly give me the steps regarding the same...


with thanx,
u&me
 

We will need to perform an rc extraction, then generate an extracted netlist and simulate.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top