Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Polarization Angle in Frequency Selective Surface simulation at CST MW Studio.

Status
Not open for further replies.
T

trstlm

Member level 2
Member level 2
Joined
Jan 28, 2010
Messages
48
Helped
8
Reputation
16
Reaction score
7
Trophy points
1,288
Visit site
Activity points
1,539
I am using CST Microwave Studio for Frequency Selective Surface (FSS) design. In the unit cell simulation setup i can change only the incidence angle. The solver generates output only for TE and TM polarization.
[Q1]But how could i simulate for polarization angles other than 0 or 90 Degree. (Ex: I want the Tx,Rx response for polarization angle of 60 Degree).
[Q2]During practical measurements antenna is rotated to get different polarizations. Practically only the incidence direction is known. But without knowing the incidence plane, how the the TE and TM polarizations are possible with practical antenna.

Please help me.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top