Pls help on LO to RF isolation for mixer in ADS ............

Status
Not open for further replies.
N

nassim1

Full Member level 4
Joined
Jun 2, 2008
Messages
195
Helped
15
Reputation
30
Reaction score
10
Trophy points
1,298
Activity points
2,515
Dear all,

How can we draw in ADS the RF to IF, LO to IF and LO to RF isolation (loss) ? is it
S12, S13 and S 23 ? i mean that, how can i configurate the HB in ADS ?

what about conversion loss vs RF frequency ?

Thanks a lot,
 

Re: Pls help on LO to RF isolation for mixer in ADS ........

Could you try placing the S parameter simulation block, then place a 50ohm terminator at the RF and LO ports, hence measure S21
 

Re: Pls help on LO to RF isolation for mixer in ADS ........

Thank you but i mean that is S21 and S12 means RF to LO isolation (loss)?

Note that: port 1 : RF and Port 2 : LO

thanks in advance
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…