Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

plese help me urgently!! unipolar stepper motor driver circuit!!

Status
Not open for further replies.
A

azaz jariwala

Newbie level 2
Newbie level 2
Joined
Jul 3, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
9
i'm going to use unipolar stepper motor 6-leads from 8051.
please gice me idea about its driver.
motor is operating on 2A, 5V. please help me.
 

Hi unipolar motors are easy to drive the center taps of the coils go to the supply voltage. the coils can then be pulled to GND using a FET. you will need 4 FET's in total one for each coil. Don't for get to add diodes across the cols to help with back EMF from the switching. If you need more help let me know.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top