Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Please HELP. Non-manifold edges found for part...

Status
Not open for further replies.
Q

qteks200

Newbie level 1
Newbie level 1
Joined
Oct 28, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,286
Hi all!
I'm a new-baby in using HFSS. I have a problem when creating a design of horn antenna. And I'm getting a error "Non-manifold edges found for part...". I don't know how to solve this problem.
I will really appreciate your comments.
 

Attachments

  • Microstrip_Antenna_TEM_Horn.rar
    42.5 KB · Views: 123

Welcome qteks200,

I took a look at your file, but there are a couple of issues before I can answer your question:

1) What version of HFSS are you using?
2) Which design are you referring to? There are two in this file.
3) There aren't any analysis setups in either design. Can you please set these up to the point where you would run it normally.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top