planar EM software simulation

Status
Not open for further replies.
M

microwave_1960

Member level 1
Joined
May 20, 2006
Messages
33
Helped
8
Reputation
16
Reaction score
4
Trophy points
1,288
Location
Poland
Activity points
1,473
Hi

I've recieved TV signal diplexer. It is working excellent (vswr and bandpass of filters are good). Circuit is made of one side Cu laminate FR-4. Is there any trick or something that gives posibility to make simulation of this kind of circuit in planar EM software?
 

Hi

The IE3D is useful for planar structure simulation. You can try to import the diplexer dxf file, that can reduce much time to draw the structure.

thanks
 
One off-topic question. Is the marked pin of your filter broken or just dirt?


Is there any reason for different distance and width of the pins of this filter?
 

johnjoe said:
One off-topic question. Is the marked pin of your filter broken or just dirt?
Click to expand...


The marked pin is in that case broken, but I've got the same working filter, it's just an example.

johnjoe said:
Is there any reason for different distance and width of the pins of this filter?
Click to expand...

That's one of the points I'd like to check by doing simulation. I don't know answer to this question either.

Thanks!
 

Ok, thanks for answering, so it was not intended to vary the distance and width.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…