Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Pipeline Modeling in Simulink

Status
Not open for further replies.

suhas_shiv

Full Member level 2
Joined
Nov 30, 2005
Messages
136
Helped
11
Reputation
22
Reaction score
4
Trophy points
1,298
Activity points
2,461
pipeline modeling

Hi guys,

I am doing a pipeline modeling using Simulink. For the sub-ADC and sub DAC I think I will have wirte a program to model them. My question is how do I call in the matlab program into simulink? I think I will have to create a sub-system and associate that program with the sub-system. How do I do this? I maybe be wrong.

Any suggestions will be helpful. Thanks.

Suhas
 

Mado_eng

Newbie level 6
Joined
Nov 16, 2005
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,366
Re: Pipeline Modeling Doubt

hi
i think you can use the simulink only without writing codes in Matlab just try to insert the non linearity of each block , i tried these days to do that my project is a pipelined adc and some trials had succeful results ,
 

suhas_shiv

Full Member level 2
Joined
Nov 30, 2005
Messages
136
Helped
11
Reputation
22
Reaction score
4
Trophy points
1,298
Activity points
2,461
Pipeline Modeling Doubt

How do you insert non-linearity? Say for the sub-ADC, what block in Simulink would you use? How would you insert the non-linearity? I think by adding an offset we can model the non-linearity. But what block would u use for sub-ADC?
 

Lantis

Junior Member level 3
Joined
Dec 29, 2003
Messages
31
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,288
Activity points
298
Pipeline Modeling Doubt

I think m-function is enough for you to model it. S function is not necesarry.
 
  • Like
Reactions: telmer

    telmer

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top