Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PICC Lite for PIC16F917

Status
Not open for further replies.

mail2rajan89

Newbie level 4
Joined
May 31, 2011
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,327
Hi,
I am using mandriva linux and also i am using the development board with PIC16F917 as the PIC IC. The problem i am facing is that the PICC lite compiler that i have downloaded compiles only to the maximum of PIC16F8X series. I am in need of PICC lite compiler for PIC16F917.. Please help me in this...
 

Have you tried the **broken link removed**? According to the literature "The HI-TECH C Compiler for PIC10/12/16 MCUs is a free-standing, optimizing ANSI C compiler. It supports all PIC10, PIC12 and PIC16 series devices, as well as the PIC14000 device and the enhanced Mid-Range PIC® MCU architecture."
 
The problem is that i have tried the HiTech C compiler.... And the compiler now i am using is not supporting for the series PIC16F917... It supports all the earlier versions of the PIC series....
 

Sound like you have an older version of the Hi-Tech Compiler. Download the latest version from the link below:

**broken link removed**

I can assure you it's supports the 16F917. It is in fact the same installation as the PRO and STD version. However, if you don't a license it runs in "Lite Mode". The major differences being code optimization and technical support, there is none.

Hope the link helps.
 
K... Thank you sir.... i have just downloaded and installed the s/w in the linux.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top