urakhai911
Newbie level 6

Hey World,
My question is regarding the CAN module in the PIC32 Ethernet Starter kit. I am running the demo program called "PIC32 CAN SID TX RX". I have been working with this program trying to get it to communicate between CAN1 and CAN2.
The problem I am having is that the output from CAN1 and CAN2 are identical and always the same waveform regardless of the data which I am outputting. I am quite certain that this must be a code problem and not a problem with the board.
Could you let me know if you have encountered a problem like this and how you would go about solving this?
P.S. I didn't post the program because it is certified my Microchip and I haven't made any modifications from the one that is available online.
Thanks!
My question is regarding the CAN module in the PIC32 Ethernet Starter kit. I am running the demo program called "PIC32 CAN SID TX RX". I have been working with this program trying to get it to communicate between CAN1 and CAN2.
The problem I am having is that the output from CAN1 and CAN2 are identical and always the same waveform regardless of the data which I am outputting. I am quite certain that this must be a code problem and not a problem with the board.
Could you let me know if you have encountered a problem like this and how you would go about solving this?
P.S. I didn't post the program because it is certified my Microchip and I haven't made any modifications from the one that is available online.
Thanks!