Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[PIC] PIC18F46K22 working with 3.3V

Status
Not open for further replies.
V

Valdez85

Junior Member level 1
Junior Member level 1
Joined
Jan 18, 2015
Messages
16
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Visit site
Activity points
125
Hi guys,

I read the datasheet of my PIC18F46K22 and i didnt see what i need to do to put my pic working in 3.3V and not 5V.

Best regards,

Álvaro Ramos
 

hello,

just power up it with 3,3V !
but :
Maximum Fosc is lower than with 5V.
Chek BOR value if you use it.
check ADC convertions +Vref =3,3V default value
Maximum internal voltage reference if used
Use of Max3223 instead of Max232 for Uart
all other parameters...depend of your application
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top