Had any body worked on Internal OScillator Configuration.
I had done following settings
1. CONFIG1h : 1000// Internal OSc Block , Port function at RA6 & RA7
2. OSSCON (SCS1:SCS0) :11// Internal Osc Block
3. OSSCON (IRCF2:IRCF0) :110 // 4Mhz
i am getting problem in working of Serial Communication and Graphical LCD
My this Problem is also Solved...by me only..
4. Should be added OSSCON(IOFS), Stability of Internal Oscillator Frequency is checked, If this bit is Stable, then only Internal Oscillator Frequency selection is Done.
---------- Post added at 05:50 ---------- Previous post was at 05:49 ----------
I had see nobody Replies in this Forum ,,,why So...