rezaf
Advanced Member level 4
Hi
I use PIC18F4550 and connected 4*4 keypad to port B but now want add MMC card to my project, the SDI and SCK pins of SPI module is in the port B that I connected keypad to that and init that in mikroBasic I used T6963GLCD too and it's data port is port D.
can I use both in same pin (keypad and mmc on RB0 and RB1)(the columns of keypad connected to this pins as input and have pull up resistors) ???
Thanks Friends
I use PIC18F4550 and connected 4*4 keypad to port B but now want add MMC card to my project, the SDI and SCK pins of SPI module is in the port B that I connected keypad to that and init that in mikroBasic I used T6963GLCD too and it's data port is port D.
can I use both in same pin (keypad and mmc on RB0 and RB1)(the columns of keypad connected to this pins as input and have pull up resistors) ???
Thanks Friends